Hardened grounded pipe shaft
Type: WH16
Outer diameter (mm): 16
Inner diameter (mm)*: 7
The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)
Material: CF53
Type: Linear Tubular Shaft with hardened surface
Recommended lubricant: ISO Standards G32-G68
Surface hardness: HRC62-64
Operating temperature: -20 °C + 110 °C
Minimum order: 0.1 meter (10 cm)
Cutting fee under 1 meter: - 1 piece free of charge - more than 1pc under 1 meter are net 150 HUF /piece.
Hardened grounded pipe shaft
Type: WH16
Outer diameter (mm): 16
Inner diameter (mm)*: 7
The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)
Hardened grounded pipe shaft
Type: WH20
Outer diameter (mm): 20
Inner diameter (mm)*: 14
*The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)
Hardened grounded pipe shaft
Type: WH25
Outer diameter (mm): 25
Inner diameter (mm)*: 15 ,6
* The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)
Hardened grounded pipe Shaft
Type: WH30
Outer diameter (mm): 30
Inner diameter (mm)*: 18 ,3
*The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)
Hardened grounded pipe Shaft
Type: WH40
Outer diameter (mm): 40
Inner diameter (mm)*: 28
* The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)
Hardened grounded pipe Shaft
Type: WH50
Outer diameter (mm): 50
Inner diameter (mm)*: 29 ,7
* The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)
Hardened grounded pipe shaft
Type: WH60
Outer diameter (mm): 60
Inner diameter (mm)*: 36
* The inner diameter is not a toleranced size. Do not use this surface as a joint surface! This value may vary from supplier to supplier. (+-15%)